Sagging headliner or worn carpet: what replacing involves
A sagging headliner and a worn carpet are two familiar signs of age inside a car in a hot climate. Neither is a fault of driving. Both come from heat, time and the way these parts are made.

How a headliner is made
A modern headliner is a stiff moulded board shaped to the roof. Its face is a thin fabric with a layer of foam bonded to its back, and that foam is glued to the board. The foam gives the soft feel and hides the board’s surface.
The whole piece is held up by the trim around it: the pillar covers, the sun visors, the grab handles and the lamps. So the fabric itself is held only by that thin foam layer and its glue.
Why the foam fails in heat
The roof of a parked car gets very hot. With heat and age the foam breaks down into a crumbly powder. Once it does, the fabric has nothing to hold on to and it drops, often at the back or around the edges first.
This is why quick mends do not last. Glue sprayed through or behind the fabric has only powder to grip, and it can soak through and stain the face. Pins hold for a while and mark the board. The lasting answer is new foam-backed fabric on a clean board.
What replacing a headliner involves
The trim around the board is removed, then the board comes out through a door or the tailgate without being folded. Where the car has curtain airbags along the roof edges, the trim over them is handled as the maker instructs and refitted with the correct clips.
On the bench, the old fabric is peeled off and every trace of old foam is cleaned from the board. A cracked board is mended. New foam-backed fabric is bonded with adhesive made for high temperatures, worked into the curves and trimmed. A sunroof adds a panel and more work.
When a carpet wears or gets wet
Carpet wears first under the driver’s heels, then along the door edge. Sand speeds it up, because grit works down into the pile and cuts the fibres. Sunlight fades the parts it reaches. Mats help, as long as they are held in place and cannot slide under the pedals.
A damp carpet is a different problem. The underlay beneath holds water against the steel floor, which smells and then rusts. Find the leak before the carpet is replaced: a door seal, a blocked drain or the drain of the air conditioning are common sources.
What replacing a carpet involves
The seats, the centre console and the sill trims come out first. Seats often carry wiring for airbags and seat-belt parts, so the battery is disconnected in the way the maker instructs before any plug is undone. With the floor bare, it is checked for rust and treated.
New carpet is either moulded to the shape of the floor or cut and sewn to fit, and it goes over new underlay. Openings are cut for the seat mounts and belt mounts, never covered over. Seats and belts go back with the bolts the maker specifies, tightened as the maker specifies.