How to plan a van fit-out: payload, space and access
A van fit-out goes well when the planning is finished before the first hole is drilled. The order matters: what the van may carry, where each thing stands, how you reach it and what holds it down. This guide takes those steps one at a time.

Begin with the payload
Every van has a payload: the weight it may carry on top of its own empty weight. The vehicle’s plate gives its loaded weight limit and a limit for each axle. The payload is that limit less the van’s own empty weight, found in the handbook or the vehicle’s papers. Check whether that figure already allows for the driver, the passengers and a full fuel tank, because they count too.
Racking, flooring, lining, water and tools all come out of the payload. Add up the weight of everything you intend to fit and everything you intend to carry before you choose materials. A fit-out that uses most of the payload leaves little for the goods the van exists to move.
Measure the floor you really have
A load space is not a plain box. Wheel arches, door steps, the bulkhead and the track of a sliding door all take room. Measure between the narrowest points, and measure at more than one height, because the walls of most vans lean inward toward the roof.
Draw the floor to scale and place the largest items first. Leave a clear aisle where a person can stand, turn and bend. A layout that looks neatly full on paper is often cramped once someone has to work inside it.
Keep the weight low and forward
Heavy items belong low down and toward the front of the load space, between the axles, not behind the rear axle. Weight carried high or far back changes how a van steers, brakes and leans in a bend. The effect grows when the van is loaded.
Balance the van from side to side as well. Water tanks, batteries and tool chests are heavy, so spread them across both sides. Each axle has its own limit as well as the van as a whole, so ask for the layout to be checked against both.
Plan access from the doors
Think about what you reach for most often, and from which door. Things used many times in a working shift should sit beside the side door or the rear door, at a height between the knee and the shoulder. Heavy things you lift out belong low.
Check that every drawer and cabinet door can open fully without meeting another one or a door frame. Nothing should have to be unloaded to reach something else. Keep the way out of the van clear, so a person inside can always leave quickly.
Fix everything to the structure
In a sudden stop, anything loose keeps moving. Racking and cabinets must be fixed to the van’s structure: its ribs, its floor and the fixing points the maker provided. Thin panel skin alone does not hold a loaded rack, and wide plates behind a fixing spread the load.
Never drill before you know what is behind the panel or under the floor. Wiring, fuel lines, brake lines, the fuel tank and, in an electric van, the drive battery sit where you cannot see them. Protect the bare edge of every new hole against rust, and never block or alter a seat-belt mount or the path of an airbag.